| Kurs | |||||
|---|---|---|---|---|---|
 | 20 - Control System / 20.04 - Drive System A backtrace records events and errors in the drive system and can be helpful in troubleshooting the drive system. The analysis can only be done by Soudronic with the help of a special program. This training shows how to copy the data from the... | ||||
 | 20 - Control System / 20.04 - Drive System This course describes the process to update the ACOPOS software. You will learn how to: download the software from the server, create an ACOPOS flash and update the machine.
B&R / drive system / ACOPOSmulti / Axis Manager X20 / POWERLINK / servo... | ||||
 | CHF 999.00 20 - Control System / 20.04 - Drive System The function of the resolver can be easily tested by using the LEDs on the resolver card. This course shows you step by step how to do this.
B&R / ACOPOSmulti / Axis Manager X20 / POWERLINK / servo amplifier / E0500 / I0028D / I0055D / I0220S | ||||
 | CHF 999.00 20 - Control System / 20.04 - Drive System A replacement is necessary if the card is defective or must be used for a test in the event of an error message from the machine.
B&R / ACOPOSmulti / Axis Manager X20 / POWERLINK / servo amplifier / E0500 / I0028D / I0055D / I0220S | ||||
 | CHF 999.00 20 - Control System / 20.04 - Drive System Servo amplifiers can be interchanged for troubleshooting. If a defective servo amplifier is identified, it must be replaced by a new one. A few points must be considered for the exchange. This training shows the exact procedure.
B&R /... | ||||
 | CHF 999.00 20 - Control System / 20.02 - CAN bus This course explains the basics of the CAN bus as well as the special features of the Soudronic machines. | ||||
 | CHF 999.00 03 - Welder / 03.07 - Welding Current Sources The PULSAR may incorrectly detect contamination even though the sheet is OK. This may be due to a number of different causes. This course presents a step-by-step procedure for resolving this problem. welding current source / 881.25 Pulsar: Too... | ||||
| CHF 999.00 03 - Welder / 03.07 - Welding Current Sources If the PULSAR shows the error "Unit Overcurrent" or "IGBT HB shorted", this indicates a defect in the PULSAR or a short circuit in the welding cable or welding transformer. This course helps you to identify the defective components. welding... | ||||
| 03 - Welder / 03.07 - Welding Current Sources If the PULSAR must be replaced, some recommendations must be followed to ensure that the new device works correctly. This course shows you the easiest way to perform this task and what points in particular require your attention.
welding... | ||||
 | CHF 999.00 03 - Welder / 03.07 - Welding Current Sources The regulator control (contamination) is activated. This normally indicates contaminated sheets. If the sheets are okay, the current regulator deviation has another cause. This course shows you how to resolve this issue step by step.
welding... |
